From the Workshop

December 4, 2018

New Workshop Blog 3

No 98 bronze lever caps

lever caps

These are the last lever caps of this type. I also used them on my mitre planes. Gone forever as the foundry closed down and my patterns are lost.

profiling cut on lever cap

After preparation including flattening, squaring etc, the profile is cut out.

No 98 lever cap part machined

The lever caps after profiling also showing centering hole to be bored to make ready for tapping

No 98 lever cap 7a

Tapping after the boring

no 98 lever cap 13

The machining for the keep recesses so the lever cap can be released after 2-3 turns on the thumb screw

DSCN0008

Ready for final shaping and polishing

No Comments »

No comments yet.

RSS feed for comments on this post. TrackBack URL

Leave a comment

You must be logged in to post a comment.

Powered by WordPress