From the Workshop

March 1, 2019

Workshop blog no 14 – No 985

I was hoping to get a little bit further than this but too many interruptions. I have finally made the decision to cut up my 416 bar for the bottoms – scary, can’t go back now. But I have been procrastinating for long enough. Especially since the bar cost £1100. Like most of my materials it is a rolled bar which needs to be planed just as you would with a piece of wood but harder work in stainless steel.

CI3A5235

This is reducing the bar down to its finished size. I am looking forward to the rest of the work.

CI3A5232

No Comments »

No comments yet.

RSS feed for comments on this post. TrackBack URL

Leave a comment

You must be logged in to post a comment.

Powered by WordPress